Page 24 1OPVM26EN – April 2018
VM26-J Maintenance
Pre-Start Inspection Checklist
The operator must conduct a Pre-Start Inspection of the machine before each work shift.
DO NOT use a damaged or malfunctioning machine.
Initial Description
Be sure that the operator's manual is complete, legible and in the storage container located in the platform.
Be sure that all decals are legible and in place.
Check for hydraulic oil leaks.
Check for battery fluid leaks.
Check the following components or areas for damage, improperly installed or missing parts and unauthorized modifications:
Electrical components, wiring and electrical cables
Battery connections and electrolyte levels
Hydraulic hoses, fittings, cylinders and manifolds
Drive motors
Slide blocks/wear pads
Tires and wheels
Ground strap
Limit switches, alarm and beacon
Nuts, bolts and other fasteners
Platform entry gate
Maintenance Lock
Platform control handle
Check entire machine for:
External marks, warping, damage or loose rivets on the lift system.
Cracks in welds or structural components
Dents or damage to machine
Be sure that all structural and other critical components are present and all associated fasteners and pins are in place
and properly tightened
Be sure that guard rails are properly installed and secured, and that all pins and bolts are properly fastened.
Be sure that the chassis is closed and latched and the batteries are properly connected.
NEVER perform work or inspection on the machine with the platform elevated without first supporting
the lift assembly.
To Next Page
Loading...