Need help?Do you have a question about the Go Power 10 AMP RVC-MPPT and is the answer not in the manual?
General| Battery Voltage Range | 8V – 16V |
|---|---|
| Battery Type | Lead Acid (AGM, GEL, Flooded), LiFePO4 |
| Max Charge Current | 10A |
| Max Panel Input Voltage | 100Voc |
| Max PV Power Input | 200W |
| Conversion Efficiency | ≤98% |
| MPPT Tracking Efficiency | >99% |
| No-Load Loss | <10mA |
| Grounding | Negative |
| Max Wire Gauge | 8 AWG |
| Operating Temperature | -35 to 45°C |
| Storage Temperature | -35 to 75°C |
| Humidity | 95% N.C. |
| Water Ingress Protection | IP32 |
| Altitude | < 3000m |
| Protection | Solar/battery reverse polarity Solar/battery over voltage Solar/battery short circuit Over temperature |
Weight and Dimensions| Dimensions (H x W x D) | 3.35” x 6.1” x 1.57” |
|---|---|
| Weight | 0.67lbs (300g) |
Overview of the 10A RV-C MPPT solar controller for smart RV systems.
Details on advanced features like MPPT, lithium battery reset, and LED fault indicators.
Quick charge stage where controller performs MPPT charging until battery voltage reaches set value.
Constant voltage charging stage where charging current gradually decreases over time.
Low current stage to maintain battery charge, switching to bulk if voltage drops.
Equalization charge stage to stir electrolytes, balance voltage, and complete chemical reaction.
Cycle completion and slow discharge until recharge voltage, initiating a new charge cycle.
Identification of the LEDs on the solar controller unit.
Describes the LED patterns and their corresponding battery status indications.
Describes the LED patterns and their corresponding PV status indications.
Lists the necessary tools and materials for installation.
Details the steps for installing and wiring the solar controller, including location, mounting, and connections.
Identifies the RV-C instance of a controller using the 5 LEDs.
Explains how to configure the RV-C instance using the SET button and LEDs.
To Next Page
