How to use your Goal Zero Yeti:
1. Press the power button located above each port you will be using. **When not using certain
ports, make sure to turn them off to conserve power.
2. You’llknow the port is turned on when the LED light on the button is illuminated.
3. Plug in your gear for power anywhere life takes you.
4. If possible, keepyour Goal Zero Yeti plugged into a power source when not in use.
5. You can charge your Goal ZeroYeti, and run your gear at the same time.
Best-Use Strategy:
Whenrecharging gearwithyourYeti,takenote of the LED Battery Display.If you plug in devices thathave a high
powerrequirement, the charge level of yourYetican dropveryquickly andyou may not getexactly 187Whof
power. On the flipside, if you’re chargingdevices thatdrawpower moreslowly (a tablet), you will get closerto
187Wh fromyourYeti.Also, especially whenusing theAC poweroutput, the GoalZeroYetiwillbe converting the
energy from theDC powerof
thebatteryto the AC powerneededby yourdevice.AlthoughyourGoalZeroYetihasa highly efficient inverter,
there is still someenergy lostin the conversionand you will not get the full rated capacityof the battery.If
you’re experiencing shorterruntimes, you maywant to checkthe device’s power requirements, see
Troubleshooting for help.
Cold Weather Usage:
Cold temperatures (below freezing) can impact the Goal Zero Yeti’s battery capacity. If you’ll be out
living off-grid in sub-zero conditions, we recommend keeping your Goal Zero Yeti in an insulated
cooler, connected to a power source (solar panels), and charging your gear. The natural heat
generated by the Goal Zero Yeti contained in an insulated cooler will keep battery capacity at its
highest.
Using your Goal Zero Yeti
LED Display + Buttons
The built-in LED display indicates battery level. Battery level displays as a number from 0 to 100.
When charging your Goal Zero Yeti you will notice a lightning bolt icon that flashes blue in the display.
This indicates the current charge status. Once your Goal Zero Yeti is fully charged, the battery level
display will read 100. Note that when you first plug in a power source, whether it’s a solar panel or a
wall charger, the Yeti may take a minute to detect and adjust its charge circuitry
before it starts drawing power from the
source.
7
6
To Next Page
Loading...
Need help?
General
