ENG - 62
The lter is used to avoid the big remnants and other sundries getting inside the pump.
The residue can obstruct the lter in sometime.
2
1
3
The lter system consists of a coarse lter, a at (Main lter)
and a micro lter ( ne lter).
Food and debris will be trapped by a special jet on the lower
spray arm.
Big debris, such as bone and glass that could clog the drain
will be trapped in the coarse lter.
To remove an item caught in this lter, gently squeeze the taps
on the top of this lter and lift it out.
This lter holds soil and food residue in the sump area and
prevents it from being redeposit on the dishes during a cycle.
- Inspect the filters for obstructions every time the dishwasher
has been used.
- By unscrewing the coarse filter, you can remove the filter
system. Remove any food remnants and clean the filters
under running water.
1
Step 1: contrarotate
2
Step 2 lift
the Coarse lter, Flat lter up
and then lift it up;
If operate from step 1 to step 2, the filter system will be removed; while operate from
step 2 to step 1, the filter system will be installed.
For best performance and results, the lter assembly must be cleaned. The lter ef ciently
removes food particles from the wash water, allowing it to be recirculated during the cycle. For
this reason, it is a good idea to remove the larger food particles trapped in the lter after each
wash cycle by rinsing the semicircular lter and cup under running water. To remove the lter
assembly, pull on the cup handle in the upward direction. The entire lter assembly should be
cleaned once a week. To clean the coarse lter and the micro lter, use a cleaning brush. Then,
reassemble the lter parts as shown in the gures above and reinsert the entire assembly in
the dishwasher, positioning in its seat and pressing downward. The dishwasher must never be
used without the lters. Improper replacement of the lter may reduce the performance level of
the appliance and damage dishes and utensils.
To Next Page
Loading...
