ENG - 66
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the height of
the dishwasher, making it level. In any case, the appliance should not be inclined more than 2.
The maximum adjustment height of the feet is 20 mm.
If the sink is 1000mm higher from the oor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or a suitable
container that is held outside and lower than the sink.
Connect the water drain hose. The drain hose must be correctly tted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be
reduced.
The waste connection must be at a height of between 50 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. The water drain hose should be xed by a hose clip.
The followings should be checked before starting the dishwasher:
1) Whether the dishwasher is level and fixed
2) Whether the inlet valve is opened
3) Whether there is leakage at the connections of the conducts
4) Whether the wires are tightly connected
5) Whether the power is switched on
6) Whether the inlet and drain hoses are knotted
7) All packing materials and printings should be taken out from the dishwasher
After installation, please put this manual into the bags of printings.
The content of this manual is very helpful to the users.
LED1, LED2 ash Door open
The door is opened when
the dishwasher is operating
LED1, LED4 ash Water inlet Water inlet malfunction
LED1, LED5 ash Water drainage Water drainage malfunction
LED1, LED6 ash Temperature sensor Temperature sensor malfunction
LED2, LED3 ash Overow/leakage Overow occurs/Water leakage occurs
LED2, LED4 ash Water leakage Water leakage occurs
LED2, LED5 ash Heating element Abnormal heating
To Next Page
Loading...
