Godox X1C - Multi Flash Settings (Times & Frequency); Multi Flash Settings (Output Value)

Setting the Transmitter
Automatically Enter Power Saving Mode
1. The flash trigger will go into standby mode after the transmitter enter sleep mode, and
the displays on the LCD panel will disappear.
2. Press any of the button (<TEST> fully pressed/<CH>/<GR>/<MODE>) can wake up
the flash trigger. If the transmitter is attached to the CANON EOS camera, half press
the shutter can also wake up the system.
3. If the transmitter is set to single contact mode( isdisplayed), the system will not
enter power saving mode.
The following table lists the available and unavailable custom functions of this flash. The
icon“√”indicates the flash custom function is supported but “0”indicates the custom
function is not supported.
Settings and Description
OFF
Master flash synchronization delay N*100 us
(synchronization delay icon is displayed.)
OFF
ON(The single contact mode set icon
is displayed.)
Setting Signs
0
1~100
0
1
Functions
Synchronization
delay setting
Single contact
mode
Custom
Functions No.
C.Fn-00
C.Fn-01
Application
√
√
- 35 -
C.Fn: Setting Custom Functions
Setting the Transmitter
- 36 -
Settings and Description
It is advisable to set the transmitter to single
contact mode when using it to trigger the flash
by PC cord or through camera’s single contact.
Do not change the zoom value.
Changing with camera's zoom value.
Zoom(20/24/28/35/50/70/80/105/135/
200mm)
PC sync socket connects with camera
PC sync socket connects with flash
Second curtain sync off
Second curtain sync on
1/128
1/256(displayed as 1/128-)
Setting Signs
1
0
AU
20,24,28,35,50,70,
80,105,135,135+
0
1
0
1
0
1
Functions
Single contact
mode
Zoom setting
PC sync socket
connects with
camera/flash
Second curtain
sync [Note 2]
Minimum power
output value in
M/Multi mode
Custom
Functions No.
C.Fn-01
C.Fn-02
C.Fn-03
C.Fn-04
C.Fn-05
Application
√
√
√
√
[Note 2]:
Second curtain sync cannot be set through the camera's external flash functions setting.
When using second curtain sync, the effective shutter speed range is from 1/30s to 30s. When shutter speed
is set as buLb or is quicker than 1/30s, the settings are invalid.
After being turned on, second curtain sync is effective even though HSS has been set and the shutter speed
range is from 30s to 1/30s.
After second curtain sync is turned on, synchronization delay settings are invalid.
√