Gold Note VALORE 425 Plus - Installing the Turntable

| INSTALLING THE TURNTABLE
6
EN
DE
IT
Platter
spindle
tip
Platter
spindle
Ball bearing
2
drops
3
drops
Platter
Bearing
housing
PLATTER
1 Remove the cap from the center of the
turntable.
2 Insert the ball bearing into the bearing
housing of the turntable taking care to
centre it on the bottom seat.
3 Add oil to spindle as shown in figure.
4 Insert the spindle into the bearing
housing.
5 Position the platter on the spindle.
6 Tighten the spindle tip onto the spindle
to lock the platter in place.
*PLEASE NOTE: the bearing housing is already
installed in the plinth of the turntable. Do not
remove it.