8
PR118 Hand Control Inside Arm Routing To move the
hand control from one side to the other, follow the instructions below.
1. Lift the bottom of outside
back from the Velcro on
the arm cross rail.
2. Remove the hand control
wire from the J-Clip.
3. Unlock the extension
wire, and separate. Note:
This step disables all
lift chair functions.
4. Route the hand control
wire through the opposite
J-Clip.
5. Reconnect the extension
wire, and lock to secure.
Extension
Lock J-Clip
Hand Control
J-Clip
P-Clip
CARE AND MAINTENANCE
Your lift chair will require routine maintenance checks. You can perform some
of these checks, while others may require assistance from a provider. By
following these maintenance checks, you can make sure your lift chair gives
you years of trouble-free operation. If you have any questions or concerns
regarding your lift chair’s care and maintenance, contact your provider.
Before cleaning your lift chair, consult your provider for the proper types
of cleaner and cleaning methods.
Keep all electrical components free from moisture and liquid spills.
Intended for indoor use only.
Periodically inspect all wiring harnesses to make sure they are not cut,
damaged, frayed, or disconnected. If damage of any type is present,
unplug the lift chair and contact your provider.
Periodically check all fasteners for tightness, wear, and corrosion. If any
of these are present, unplug the lif t chair and contact your provider.
Warning: Be careful of pinch points and sharp metal parts (wear
gloves).
Replace the batteries after one use. Replace the batteries yearly, even if
they were not used. Batteries are intended for one use only!
To Next Page
Loading...
