9
DOOR PANEL INSTALLATION
Adjusting the door panel communication volume:
If after starting the system the door panel audio volume seems inadequate, follow these steps:
- Call an apartment.
- The call is received in the apartment. Establish communication by pressing the push button on the monitor.
- Next, press the push button used to call the apartment for 3 seconds until a number of confirmation tones are
heard and the door panel communication LED starts to blink.
- Each press on the same call button will increase the door panel volume and LED blink speed.
.
There are 5 volume settings and the blink speed of LED will increase for each. Slow to fast blink - low to
high volume. After reaching “setting 5”, that is, maximum blink speed and volume, the next setting is “setting
1”, that is, minimum blink speed and volume (carousel mode).
-To save the volume setting keep the push button used to call the apartment pressed until a number of
confirmation tones are heard and the door panel communication LED turns off.
NEXA MODULAR GB2 VIDEO DOOR ENTRY SYSTEM KIT - VILLAS
Selecting the vocal synthesis language:
To activate the voice synthesis of the door panel, follow these steps:
- door panel.Remove the power supply in the
- 7 .Set dip 6 of the sound module's configuration dip switch to ON (see page )
- .Connect the power supply in the door panel
- Press the sound module' s P2 push button for 6 seconds (until finish the confirmation tones).
- Each press will change the language. Continue doing this until the desired language is
heard.
- fOnce finished set dip 6 o the configuration dip switch to OFF. A confirmation tone will be
heard.
Adjusting the voc synthesis volumeal :
If after starting the system the voc synthesis volume of the door panel seems inadequate,al
follow these steps:
- door panel.Remove the power supply in the
- 7 .Set dip 6 of the sound module's configuration dip switch to O (see page )FF
- .Connect the power supply in the door panel
- Set dip 6 of the sound module´s configuration dip switch to ON.
- Press the sound module's P2 push button for 6 seconds (until the sysnthesis volume is
heard and led ).the door panel starts to blink.
- led .Each press will increase the synthesis volume and the blink speed
There are 5 volume settings and the blink speed will vary for each. Slow to fast blink - low to high volume. Afterled
reaching “setting 5”, that is maximum blink speed and volume, the next setting is “setting 1”, that is minimum blink
speed and synthesis volume (carousel mode). Stop pressing P2 when the desired synthesis volume is selected.
- f and the door panelOnce finished set dip 6 o the configuration dip switch to OFF. A confirmation tone will be heard
led turns off.
To Next Page
Loading...
Need help?
General
