3
CHARACTERISTICS
- telephone with simplified installation (non-polarised 2 wire bus).T-ART
- Up to 4 telephones/monitors per apartment (master, slave 1, slave 2 and slave 3).T-ART
- Up to 32 apartments/T-ART terminals in mixed installations with monitors .(EL632 G2+ SE module)
- Up to 128 apartments/ terminals per installationT-ART (EL6 2 G2 sound module required).4 +
- Completely private conversation.
- Call reception volume control: min, med, max and off (do not disturb).
-Audio volume control during communication process (4 different levels).
- nput for calls from door."HZ" i apartment front
- Output to auxiliary call repeater (maximum 50mA/12Vdc).
- ifferent ringtones to identify the origin of the call (door panel, intercom or door of theUp to 6 d , guard monitor front
apartment).
- Button for lock release 1 activation/ activate/ deactivate "Doctor mode".
- Button for lock release 2 activation/ staircase light activation (SAR-G2 SAR-12/24 modules required)+ & /
"intercom" calls (within the same apartment) and "autoswitch-on" function.
- Button for tone call volume control, "do not distrurb" mode/ configuring ringtones/ communication call volume control
(T-ART speaker) & in case of call forwarding, cancel call transfer (withART 7W monitor).
- Button for guard monitor calls (if exist).
- DIP switches for setting the telephone's address (call code), master/slave and end of line.
SYSTEM OPERATION
T-ART/G2+ TELEPHONE
- To make a call, the visitor needs to press the button for the apartment, an audible tone indicates that the call is being
made and LED on the door panel illuminates. If vocal synthesis is enabled, a 'Call is in progress' message appears
indicating that a call is being made. At this moment, the apartment's te (s) receives the call. If anotherlephone
apartment is called by mistake, press the button for the correct apartment and the first call will be cancelled.
- Upon receiving the call, the telephone’s LED will blink white. the doorIf the call is not answered within 40 seconds,
panel’s , the telephone’s LEDLED will turn off and the channel will be freed.
switch on (white color)
- ’s will turn off, theDoor panel LEDTo establish communication, lift the handset on any telephone in the apartment.
led turn on and the telephone’s LEDwill .switch on (white color)
-
Communication will last for one and a half minutes or until . When communication has finished,the handset is replaced
door panel’s enabledLED will turn off and the channel will be freed. If vocal synthesis is , a 'Communication is
finished' message will indicate that the call is over.
- To open the door, press button (if it exists and, to open the second door, press button ) during the call or
communication processes: one press activates the lock release for seconds and LED on the door panel will also3
illuminate for seconds. If vocal synthesis is enabled, a 'Door en' message will be indicated on the door panel.3 is op
- Description of the function buttons can be found on p. .4