basket and not against the bellows. Slightly open the water supply valve since the pressure in
the chamber should not exceed 1 bar. The pressing takes 6 to 10 hours, depending on the
size of the press.
When pressing the wine sediment and lees use original bags of the appropriate
size in order to avoid damage to the bellows. Pressing the lees and the wine
sediment using pressure higher than 1 bar can damage the bellows. This is
regarded as mechanical damage and is therefore not covered by warranty!
If the pressure during pressing is higher than 1 bar the pressing time will not be
shorter.
8. SAFETY IN USE OF THE MACHINE
– The machine can be used only by professionally trained and healthy persons older than 18
years.
– While operating the machine must not be moved or displaced.
– While operating the machine must not be cleaned or repaired.
– For the user's safety the machine must not be charged with air.
– However, it is necessary to give an assurance that the outlet connector of the
safety valve is unhindered!
– Never press without the lid!
Before first use of the machine one must:
– carefully read and comprehend the contents of these instructions,
– look for all warnings, symbols and inscriptions on the machine, and discover their meaning
in these instructions, Chapter VII,
– read the instructions and get to know all parts of the machine and their functions, Chapter
IV,
– pay attention to the instructions before every use of the machine.
Before every use of the machine one must:
– pay attention to the instructions before first use of the machine.
– check the machine before every use; the description of the procedure can be found in
Chapter VI,
– check that all parts of the machine are in prime condition,
– put the machine on firm, level ground that is not slippery and allow at least 2m2 surface for
use,
– pay attention the to machine's biggest incline which must not be bigger than 1 degree of
arc, and the lined element must not be taller than 10mm,
– make sure that the illumination of the machine and work space is sufficient (at least 150
Lux),
– people who work with the machine must wear tight clothes, protect long hair and wear no
jeweler, ties or similar items,
– make sure that working with the machine threatens nobody in the vicinity and that there are
no children nearby,
– make sure that work space surroundings are tidy and not cluttered with other items,
To Next Page
Loading...