GoMax Electronics MA-5188C - Method 2: Front Panel Operation

~ 19 ~
Method 2: Use the front panel of the master unit
Button
Function
Output Port
EDID will be read from display via the connected receiver unit from the
respective output port
Input Channel
The EDID will be sent to the input source connected to respective
HDMI input port
One by One learning
1. Select the desired Output Port and Input Channel that you want the EDID of the display
connected to this specified output port can be learned for the specified input channel.
2. Press the “+” button of the Output Port and “−” button of the Input Channel” at the same time
for 2 seconds.
3. Release these two buttons. The EDID will be read from the receiver unit connected to the display
and sent the Output Port then written to the chosen Input Channel.
4. If the operation is successful, the Input Channel will show “O” (OK). If the operation is not
successful, it will show “F” (failure).
One to All learning
1. Press the “” button of the Output Port and the “” button of the Input Channel” at the same
time for 2 seconds.
2. Release these two buttons. . The EDID will be read from the receiver unit connected to the display
and sent the Output Port then written to all eight Input Channels.
3. If the operation is successful, the Input Channels will show “O” (OK). If the operation is not
successful, it will show “F” (failure).