~ 7 ~
SW1-SW8 for EDID/Audio
Note
1
If the HDTV shows video but without audio, please try to set audio mode to stereo.
2 Factory default setting of [SW1]-[SW8] is pin-1 at OFF [
] & pin-2 at OFF [
] for 1080p video and
surround sound audio.
3 If you encounter any unsolved audio/video output problem during system installation, please turn
any [SW1]-[SW8] to pin-1 at OFF [
] & pin-2 at ON [
] for safe mode to enforce the system output
up to 1080p video and stereo audio for system check. However, the safe mode cannot be initiated
if your HDMI™ source is set to enforce 1080p output. In this case, please reconfigure your HDMI™
source to all resolution output for troubleshooting.
4
Bypass means the matrix will maintain playing the original format of HDMI signals in video and
perhaps audio. By setting at this mode, the users may encounter compatibility issue among different
kinds of HDMI sources and displays. If you cannot get the audio and/or video output normally at the
system installation, please change the DIP switch setting to default mode or even safe mode to
verify the functionality of the device.
5
To learn the EDID of HDMI display for respective HDMI source devices, please see the [EDID Learning]
section in the next page for more detail information.
EDID Learning & Stereo Mode
5
– for learning EDID from
the display while enforcing stereo output if any HDTV cannot
play surround sound normally
To Next Page
Loading...