To Next PageTo Next Page
Need help?Do you have a question about the Goodman ComfortNet DSXC160241AF and is the answer not in the manual?
General| Type | Heat Pump |
|---|---|
| Cooling Capacity (BTU) | 24000 |
| SEER Rating | 16 |
| HSPF Rating | 9.5 |
| Refrigerant | R-410A |
| Voltage (V) | 208/230 |
| Phase | 1 |
| Stages | 2 |
Introduction to the ComfortNet™ system and its product lines.
Essential safety guidelines for handling refrigerants, including ventilation and protective gear.
Chart detailing symptoms, causes, tests, and remedies for cooling and heat pump issues.
Procedure for testing system voltage and locked rotor voltage.
Troubleshooting steps for the ComfortNet™ system network.
Table detailing LED indicators, causes, and corrective actions for communication issues.
Troubleshooting codes for PCBJA101 and PCBJA102 air handler control boards.
Troubleshooting codes for PCBJA104 air handler control boards.
Guide to interpreting diagnostic codes from the Copeland Comfort Alert™ system.
Troubleshooting low side pressure faults and related error codes.
Troubleshooting compressor faults like locked rotor and open circuits.
Troubleshooting electrical faults including low/high line voltage.
Troubleshooting codes for sensor failures and blown fuses.
Troubleshooting network communication and system mismatch errors.
Troubleshooting configuration mismatches and low side refrigerant faults.
Troubleshooting high side pressure faults and related error codes.
Troubleshooting short cycling and locked rotor conditions.
Troubleshooting open circuits and low line voltage issues.
Troubleshooting codes related to voltage issues and compressor protector trips.
Procedure to test the high pressure control cutout.
Safety warnings and procedures for checking hermetic compressor terminals.
Procedure for testing compressor winding continuity.
Procedure for testing compressor windings for ground faults.
Procedure to verify the operation of the unloader using Comfort Alert™.
Testing compressor operation if other tests fail.
General practices and safety precautions for refrigeration system repair.
Procedure for leak testing refrigeration systems using nitrogen.
Procedure for evacuating the system to remove air and moisture.
Procedure for charging the system with refrigerant.
Procedure to check compressor efficiency by examining scroll flanks.
Procedure for checking superheat and related calculations.
Procedure for checking subcooling and its calculation.
Procedure to check the expansion valve's operation and identify restrictions.
Procedures for diagnosing and cleaning after compressor burnout.
Importance of refrigerant piping for system capacity and oil return.
