To Next PageTo Next Page
Need help?Do you have a question about the Goodman ComfortNet DSXC160601BC and is the answer not in the manual?
General| Brand | Goodman |
|---|---|
| Model Number | DSXC160601BC |
| Category | Heat Pump |
| Cooling Capacity (BTU/h) | 60000 |
| SEER | 16 |
| HSPF | Up to 9.5 |
| Refrigerant | R-410A |
| Compressor Type | Scroll |
| Stages | 2 |
| Heating Capacity (BTU/h) | 60000 |
| Voltage | 208/230 |
| Phase | 1 |
Guidelines and warnings for the safe handling and use of refrigerants.
Description of the UC PCB's role in communicating HVAC systems and its diagnostic features.
Explanation of how the defrost cycle is controlled and initiated in ComfortNet™ systems.
A guide to diagnosing system problems based on symptoms and possible causes.
Procedures for checking voltage, wiring integrity, and ComfortNet™ thermostat system setup.
Procedure for checking the time delay relay used in electric heater sequencing.
Steps to verify the operation of compressor contactor and relay contacts.
Procedure for verifying high and low voltage supply to the motor.
Procedures for troubleshooting network communication issues using LEDs and the learn button.
Using Comfort Alert™ diagnostics for ASXC, ASZC, and DSZC models.
Table mapping 7-segment LED displays to operational conditions and faults.
Detailed table of diagnostic codes, causes, and corrective actions for air handler control boards.
Procedure for testing the high pressure control switch for proper cut-out pressure.
Procedure for testing the low pressure control switch for cut-out and cut-in pressures.
Method for checking voltage across high and low pressure switches.
Explanation of the function and testing of run capacitors.
Steps for performing resistance checks on components using a digital multimeter.
Procedure for checking capacitor capacitance using a digital multimeter.
Detailed checks for Emerson Ultratech™ ECM motors used in AVPTC/MBVC models.
Safety precautions and procedures for checking hermetic compressor terminals.
Procedure for testing compressor winding resistance for single-phase units.
Procedure for checking compressor windings for ground faults.
Steps to verify the operation of the compressor unloader using Comfort Alert™ diagnostics.
Procedure for testing compressor start-up and operation using a test cord.
Steps to check the reversing valve for proper operation and voltage.
Procedure for checking the defrost control's sequencing and operation.
Procedure for checking outdoor air and coil temperature sensors for resistance.
Procedure for checking the heater limit control for continuity.
Procedure for checking the one-time fuse link that protects each heater element.
Procedure for checking heater elements for continuity and visual defects.
General practices for refrigeration system repair, including brazing materials and safety.
Methods for leak testing refrigeration systems using dry nitrogen.
Procedure for evacuating the system to remove air and moisture.
Steps for charging the system with the correct amount of refrigerant.
Method to check compressor efficiency by examining scroll flanks and performance test results.
Procedure to test the expansion valve's power element and equalizer tube operation.
Detailed table of diagnostic codes, causes, and corrective actions for air handler control boards.
