IO137 23
ROTATION OF VENT BLOWER
THE VENTER ASSEMBLY MAY BE ROTATED TO FIT THE VENTING REQUIREMENTS.
REMOVE THE FOUR PERIMETER SCREWS, ROTATE THE VENTER TO THE DESIRED
POSITION AND REINSERT AND TIGHTEN THE SCREWS. THE ORIFICE PLATE MUST
BE ROTATED ALONG WITH THE VENTER ASSEMBLY FOR PROPER COMBUSTION
AND IGNITION. A LOCATOR PIN IS PROVIDED FOR THIS PURPOSE. DO NOT
USE
SELF PIERCING SCREWS TO SECURE THE VENT TO THE PLASTIC CHIMNEY. USE A
DRAFT HOOD CONNECTOR OR THE SELF DRILLING SCREWS SUPPLIED WITH THE
FURNACE.
VENTER SHOWN IN THE RIGHT SIDE VENT POSITION.
NOTE POSITION OF LOCATING PIN.
LOCATING PIN
VENTER SHOWN IN THE (AS RECIEVED) VERTICAL VENT
POSITION. NOTE THE POSITION OF THE LOCATING PIN.
NOTE POSITION OF LOCATING PIN.
LOCATING PIN
VENTER SHOWN ROTATED IN THE LEFT VENTING
POSITION. NOTE THE POSITION OF THE LOCATING PIN
LOCATING PIN
To Next Page
Loading...
