Quick Setup3
Setting up3.1
1. Unbox your CD Micro System and check that you have all the components.
3. Unbox your CD Micro System and check that you have all the components.
2. Line the projections on the base up with the holes in the bottom of the CD Micro System and
push in until they click.
6. Open the CD cover and carefully remove
and discard the white card tab from inside the CD
compartment.
4. Unwind and extend the aerial.
5. Remove all transparent protection film from the player.
Using the Remote Control3.2
Setting the Clock3.3
9. Connect the mains
power adaptor to the mains power supply.
Your CD Micro System is now ready for use.
7. If there is a protective strip in the battery compartment, remove it before using the remote
control.
8. Connect the mains power adaptor to the DC-in socket.
To use the remote control, point it towards the sensor at the front of the CD Micro System.
1. With the CD Micro System in standby, press and hold the FUNC button until the display
2. (Optional) Press the TUNE-/SKIP- or TUNE+/SKIP+ button to switch between 24H and
12H display.
flashes 24H. Release the FUNC button.
The remote control will work up to 6 metres from the CD Micro System and at an angle of up to
30 degrees.
Do not block the path of the beam from the remote control to the CD Micro System.
3. Press the FUNC button. The time is displayed with the hours flashing.
4. Press the TUNE-/SKIP- or TUNE+/SKIP+ button to set the hours value.
5. Press the FUNC button. The time is displayed with the minutes flashing.
6. Press the TUNE-/SKIP- or TUNE+/SKIP+ button to set the minutes value.
7. Press the FUNC button. The clock displays the selected time.
Note: Sunlight or very bright light will reduce the remote control sensitivity.
GMC01
To Next Page
Loading...
