What does Fac Failure mean on Goodwe GW2500-NS Inverter?
A 'Fac Failure' on your Goodwe Inverter means it is not connected to the grid. Check if the power grid is connected to the cable, and check the availability of the power grid.
How to fix a Relay-Check Failure on a Goodwe GW2500-NS?
To address a Relay-Check Failure on your Goodwe Inverter: 1. Turn off the DC switch of the inverter. 2. Wait until the LCD light is off. 3. Turn on the DC switch and ensure it is connected.
What does Isolation Failure mean on my Goodwe GW2500-NS Inverter and how can I resolve it?
An 'Isolation Failure' on your Goodwe Inverter suggests a problem with the impedance between the ground and PV (+) & PV (-). Check the impedance; the value must be greater than 100kΩ. Also, ensure the inverter is properly grounded.
What to do if my Goodwe GW2500-NS Inverter displays PV Over Voltage?
If your Goodwe Inverter is showing a 'PV Over Voltage' error, check if the PV open circuit voltage is higher than or too close to the maximum input voltage.
Why does my Goodwe GW2500-NS Inverter show Utility Loss?
A 'Utility Loss' message on your Goodwe Inverter indicates a disconnection from the power grid. Check if the power grid is connected to the cable and verify the availability of the power grid.
What to do if my Goodwe Inverter shows a Vac Failure?
If your Goodwe Inverter displays a Vac Failure, it means there's an issue with the grid voltage. First, the inverter will automatically restart within 5 minutes if the grid returns to normal. Ensure the grid voltage conforms to the specified requirements. Also, verify that the neutral (N) wire and PE cable are securely connected.
What to do if my Goodwe GW2500-NS Inverter shows a Utility Loss error?
General| Model | GW2500-NS |
|---|---|
| Rated Power | 2500 W |
| Max. DC Power | 3000 W |
| Max DC Input Voltage | 600 V |
| Number of MPPT | 1 |
| Efficiency | 97.5% |
| Max. AC Apparent Power | 2500 VA |
| Rated Output Voltage | 230 V |
| THDi | <3% |
| Cooling Method | Natural cooling |
| Protection Degree | IP65 |
| Max. PV Input Power | 3000 W |
| Output Frequency | 50/60 Hz |
| Operating Temperature Range | -25°C to 60°C |
Introduction to the GoodWe NS & DNS series of solar inverters.
Provides guidelines for mounting and selecting the optimal installation location, including clearance distances.
Guides through the inverter booting process, safety country selection, and time setting.
Step-by-step instructions for setting up WiFi monitoring for the inverter.
Instructions for configuring the Ezlogger Pro with LAN for device communication and setup.
Details dynamic and static IP configuration methods for the Ezlogger Pro.
Details the standard manufacturer's warranty period, terms, and claim procedures for inverters and accessories.
To Next Page
