English • Owner´s manual
28
Fig. 8
POWER ON TURNED OFF
Fig. 9
G
H
Fig. 10
Fig. 11
Fig. 12
On / O
1. Pull the pressure switch up to turn on, the compressor starts and injects air into the tank through the
supply line (Fig. 8).
2. To switch o the compressor, press the switch to turn o. The compressor continues to run according to
the automatic cycle until the output line switch is turned o.
WARNING:
Always disconnect the plug and drain the tank once you have completed your work.
Always wait at least 10 seconds after the compressor shuts o before restarting it.
To Next Page
Loading...
