How to stop Gorenje W9865E from moving?
If your Gorenje Washer is moving during operation, it's likely that the machine isn't properly leveled. Use the adjustable legs to level the machine. Also, ensure that the transport brackets have been removed.
Why Gorenje W9865E Washer is not turning on?
If your Gorenje Washer is not working and the display is not lit, check if the machine is powered. Ensure there is power in the socket, the fuse is OK, and the plug is properly inserted into the socket.
What to do if Gorenje W9865E shows ERROR 07?
If your Gorenje Washer displays ERROR 07 and the water isn't pumping out correctly or at all, there might be a clog in the water outlet. Check if the filter is clean, the outlet pipe isn't jammed, the drain isn't clogged, and the outlet pipe is not positioned higher than 1 meter. You can also try pushing the START button again.
What to do if Gorenje Washer shows ERROR 03?
If your Gorenje Washer displays ERROR 03, indicating that water isn't being supplied to the machine, first check if the water tap is open. Also, ensure that the inlet pipe net filter is clean. Finally, push the START button.
What to do if Gorenje Washer shows ERROR 02?
If your Gorenje Washer displays ERROR 02 and the washing program doesn't start, with the actual time flashing, it indicates that the door is either open or not properly closed. Close the door firmly by pushing it towards the machine and then push START again.
Why is Gorenje Washer taking so long?
If your Gorenje washer is taking longer than usual to complete a cycle, and the time on the display is changing during the wash, this could be due to several reasons. The inlet water may be at a low temperature, which can extend the washing program time by up to 60%. The machine may have also activated the UKS system because of an uneven laundry load. Low mains voltage can also cause the program to run longer, and additional rinses might prolong the wash time. There may have also been a failure in the power supply.
How to fix water leaking from Gorenje W9865E Washer?
If water is leaking from your Gorenje Washer, make sure the filter is tightly screwed in. Also, check that the inlet pipe is securely fastened to both the machine and the water faucet. Ensure that the outlet pipe is correctly affixed to the drain, not left on the floor.
Why is my Gorenje W9865E Washer vibrating so much?
If your Gorenje Washer is vibrating excessively during the spin cycle, it's likely due to unevenly distributed laundry, especially when washing very small loads. This is normal; the machine will reduce the RPM if vibrations are too strong. Try washing a larger quantity of laundry.
What to do if Gorenje W9865E Washer shows ERROR 06?
If your Gorenje Washer displays ERROR 06, indicating that the program temperature hasn't been reached, it could be due to a heater failure or the inlet water being too cold. Turn off the appliance, wait a few seconds, then turn it back on and repeat the washing program. Note that manual addition of water may also cause this error. If the failure is reported again, call a service technician.
Why is my Gorenje W9865E foaming too much?
If you're experiencing excessive foaming during washing with your Gorenje Washer, it's likely due to using too much detergent. Use washing powder according to the manufacturer's instructions, considering the water hardness and how soiled the laundry is. Be sure to use only detergents specifically designed for machine washing.
Essential guidelines for safe operation and user protection.
Step-by-step guide to removing transport safety devices.
Guidance on choosing a location and levelling the appliance.
Instructions for connecting the water supply hose and Aqua-Stop.
Guide for connecting the drain hose to various outlets safely.
Adjusting washing mode, temperature, and spin speed.
Information on error codes and environmental interference.
Table detailing common problems and their solutions.
General| Water consumption per cycle | 57 L |
|---|---|
| Energy consumption washing per cycle | 0.75 kWh |
| Annual water consumption washing | 11470 L |
| Annual energy consumption washing | 170 kWh |
| Door color | Silver |
| Door hinge | Left |
| Drum volume | 64 L |
| Control type | Buttons, Rotary |
| Display type | LCD |
| Loading type | Front-load |
| Drum material | Stainless steel |
| Product color | White |
| Built-in display | Yes |
| Door opening angle | 180 ° |
| Appliance placement | Freestanding |
| Inverter technology | No |
| Drum capacity | 9 kg |
| Cycle time (max) | 188 min |
| Residual moisture | 44 % |
| Spin-drying class | A |
| Maximum spin speed | 1600 RPM |
| Noise level (spin) | 72 dB |
| Noise level (wash) | 49 dB |
| Number of washing programs | 31 |
| Package depth | 685 mm |
| Package width | 640 mm |
| Package height | 920 mm |
| Package weight | 81500 g |
Weight and Dimensions| Width | 600 mm |
|---|---|
| Height | 850 mm |
| Weight | 79500 g |
| Door opening diameter | 340 mm |
To Next Page
