WARNING! Read the section that follows very carefully before installing your
equipment. It gives the safety instructions to follow during installation.
The electrical installation to which the equipment is connected must comply with
the NF C 15-100 standard.
This device does not have a primary power switch. A power protection system (cir-
cuit-breaker or disconnecting switch), easy to access must be built into the wiring
installation. This device must support the nominal voltage and current values spe-
cied on the clock.
In Europe: to comply with European regulations on the protection of persons and
the environment, you must dispose of this equipment in a collection site provided
for this purpose (separately from household waste). Contact your reseller, collec-
tion site or the competent lcoal authorities for more information.
Modifying or opening the product without the consent of the Customer service
department will void the warranty.
All maintenance operation shall be conducted with power shut off, including sys-
tems connected on relay outputs if any.
Gorgy Timing disclaims all responsibility in case of accident or damage caused by
an improper use of the product.
EN 55022, EN 50024
IMPORTANT SAFETY INSTRUCTIONS
To Next Page
Loading...
