2-way Paging Features
The paging unit is designed to alert you when either of the following sensors
are activated.
1. Current Sensor
2. Tilt Sensor
3. Shock Sensor
4. Warn Away
The alarm and 2-way paging system have a transmission range of up to
1/2 mile. If the system is interrupted by strong radio frequency, high
voltage electrical power or obstacles like tall buildings, the transmission
range may be shortened.
*
*
If the system is interrupted by strong radio frequency, high voltage electrical power or obstacles
like tall buildings, the transmission range may be shortened.
5-BUTTON 2-WAY PAGER FEATURES
Setting the clock:
To set the time on 5-button pager.
STEP 1
Press and hold the red button for 3 seconds. You will hear three
confirmation beeps.
STEP 2
The hour begins to flash. You can change the hour up by pressing the button
or down by pressing the button.
STEP 3
After selecting the hour press the button again to move to the minutes.
You can increase the minutes by pressing the button or decrease the minutes
by pressing the button.
STEP 4
Once you selected the proper time, wait approximately 10 seconds.
You will hear one confirmation beep and the time is set.
To Next Page
Loading...