5-Button Pager Screen Lamp:
To illuminate your pager screen.
STEP 1
Press and hold the set button for 1 second. The screen will stay illuminated
for 5 seconds.
Setting the Vibration Mode:
The pager unit will vibrate when the system is triggered instead of sending
audio tones.
STEP 1
To set the vibration mode press set button quickly then press button
and hold for 2 seconds. Vibration icon will appear on screen.
STEP 2
To return to ringing mode repeat the above process.
In Range Indicator:
The in range indicator shows whether you are within the remote control range.
The range is up to 1/2 mile. If the system is interrupted by strong radio
frequency, High voltage electrical power or obstacles like tall buildings, the
transmission range may shorten.
STEP 1
To check if you are in range press the lock or button insert icon.
The in-range indicator will disappear if you are out of range.
Power Save Mode:
Set your 5-button transmitter to conserve the pager battery life.
If the motorcycle alarm is not going to be used for a length of time, activating the
pager’s power save mode will keep your pager’s battery from being drained.
STEP 1
Press and hold the button for 10 seconds, you will see the word (SAVE)
above the battery icon.
STEP 2
To exit the battery power save mode press button, or any button on the pager.
To Next Page
Loading...