5
3 pin connector
(Lead for optional 2-way pager system)
DIAGRAM 2
Programming the Alarm
The remote transmitter supplied is randomly coded with one of over 500,000
different code sequences. After wiring is completed, you are now able to
program the alarm unit with your transmitter’s individual code.
Programming the Remote Transmitter
Push button on the first Remote Transmitter within 10 seconds of
connecting Power to Alarm. You will hear 1 chirp.
NOTE: You can program up to 2 additional Remote Transmitters. Each additional Remote Transmitter
must be programmed within 10 seconds of the previous remote.
Programming the Second Remote Transmitter
Press button of the Second Remote Transmitter within 10 seconds of
programming the first Remote Transmitter. You will hear 2 Chirps.
Programming the Third Remote Transmitter
Press button of the Third Remote Transmitter within 10 seconds of
programming the Second Remote Transmitter. You will hear 3 Chirps.
After programming your Remote Transmitter(s) you must wait 10 seconds to exit
programming mode. The Gorilla alarm in now programmed.
NOTE: The alarm unit will accept a maximum of 3 codes.