Alarm Operation
1. Press the transmitter button once to arm the alarm.
You will hear one (1) chirp.
2. Press button once to disarm your alarm. You will hear two
(2) chirps. When four (4) chirps are heard, it is a signal that your alarm
has been activated in your absence.
3.
Your alarm has a panic feature which allows the transmitter to activate the
alarm’s siren from up to 100 feet away in case of an emergency. To use
this feature, press transmitter button and hold for more than
three (3) seconds.
4.
When parking in a location where conditions may inappropriately activate
the shock sensor, such as multi-level parking structures or heavy construction
sites, you may turn off (de-activate) the shock sensor feature. To do this
press button 3 times within 5 seconds. You will hear 1 chirp and 2 beeps.
6
Arm Alarm System
Disarm Alarm System
Activate Panic Mode
Arm “Warn Away”
Mode Only
Deactivate Shock Sensor
Programming Siren Sound
Programming Shock
Sensitivity
You will hear 1 chirp
You will hear 2 or 4 chirps
You will hear 1 chirp & 1 beep
You will hear 1 chirp & 2 beeps
First press button to disarm
alarm. Begin operation within
5 seconds of disarming alarm
First press button to disarm
alarm. Begin operation within
5 seconds of disarming alarm
Press button once
Press button once
Press & hold button or 3 seconds
Press button twice within
5 seconds
Press the button 3 times within
5 seconds.
Press & hold the button for
3 seconds. Then press the button
to scroll through sounds
Press & hold the button for
3 seconds. Then press the button
to scroll through 7 sensitivity levels
SYSTEM FUNCTION TRANSMITTER OPERATION REMARK
To Next Page
Loading...
Need help?
General
