Two Stage Shock Sensor
The purpose of the shock sensor is to sense any disturbance, jolt or impact to the
motorcycle. This alarm is designed to activate two ways.
1. A light disturbance will cause the alarm to sound a single chirp. This
“warn away” feature notifies the violator that the motorcycle is alarmed.
2. A stronger disturbance activates the alarm for a full 30 seconds.
NOTE: If the alarm’s shock sensor is set to sensitive, the “warn away” feature will
be by-passed and the alarm will sound for a full 30 seconds.
Setting the Shock Sensor in the “warn away” mode only
1. Pressing button twice within the 5 seconds you will hear 1 chirp and 1 beep.
2. Any disturbance will cause the alarm to sound a single chirp only. This
“warn away” feature notifies the violator that the motorcycle is armed.
NOTE: Your motorcycle will still be protected by the tilt/current sensors.
De-activating the Shock Sensor
When parking in a location where conditions may inappropriately activate the
shock sensor, such as multi-level parking structures or heavy construction sites,
you may turn off (de-activate) the shock sensor feature.
1. To do this press button 3 times within 5 seconds. You will hear 1 chirp
and 2 beeps.
NOTE: Your motorcycle will still be protected by the tilt/current sensors.
Current Sensor
The alarm is equipped with a current sensor that will activate the siren if
there is any disturbance to the electrical system, such as an attempt to hotwire
the motorcycle.
10
Important: Each sensor (TILT, SHOCK, CURRENT) has a 5 second delay. It is
suggested that you count to 10 before testing.
Important: Each sensor (TILT, SHOCK, CURRENT) has a 5 second delay. It is
suggested that you count to 10 before testing.
To Next Page
Loading...
Need help?
General
