9
LED Function Chart
When your alarm has been activated, the LED Warning Light will start to flash in the
programmed sequence identifying which sensor has been triggered, as shown below:
No. of Flashes Alarm Mode
None Alarm is disarmed
Constant Alarm is armed
1 Flash Current sensor was activated
2 Flashes Tilt sensor was activated
3 Flashes Shock sensor was activated
After the alarm has been deactivated, the LED Warning Light will continue flashing for
approximately 15 seconds, identifying which sensor has been triggered.
NOTE: Installation of the LED is not required for alarm operation.
Panic Feature
Your alarm has a panic feature which allows the transmitter to activate the
alarm’s siren from up to 100 feet away in case of an emergency. To use this
feature, press button and hold for more than 3 seconds. To disarm the panic
mode press the button. You will hear 2 chirps. Disarming panic mode does
not disarm alarm.
False Alarm Circuit:
Your alarm is equipped with a “false alarm circuit” to prevent wearing your
motorcycle battery down.
Should the same sensor be repeatedly triggered (due to thunder, jack hammers,
airport noise or other conditions) the alarm will shut down that sensor after the
5th false alarm.
NOTE: The remaining 2 sensors will still protect your motorcycle.
To Next Page
Loading...
Need help?
General
