CONGRATULATIONS! You have purchased one of the most compact and effective
motorcycle alarms on the market today. With most motorcycles, installation takes less
than 30 minutes and can be done with common hand tools.
The Gorilla Cycle Alarm protects your motorcycle by detecting disturbances such as
bumping and moving or any current drop in the electrical system. When activated,
the 120db Piezo siren will sound for 30 seconds before stopping and then re-arms itself.
Gorilla Remote Control Cycle Alarm components
Your Gorilla Remote Control motorcycle alarm was carefully packaged at the
factory, however we recommend that you closely examine the contents to be sure that all parts
are included. If a part is missing, call the Gorilla Installation Helpline at (800) 262-6267, and a
replacement part will be sent.
Gorilla Cycle Alarm / 7007
QUANTITY DESCRIPTION
1 ALARM UNIT WITH MOTION TILT SENSOR
2 HOOK & LOOP STRIPS
1 MOUNTING BRACKET
1 3-BUTTON REMOTE TRANSMITTER
2 SQUARE HEAD BOLTS
2 HEX NUTS
2 PHILLIPS/HEX HEAD SCREWS
2 SMALL LOCK WASHERS
2 LARGE LOCK WASHERS
2 SMALL FLAT WASHERS
2 LARGE FLAT WASHERS
2 PLASTIC WIRE TIES
1 LED WARNING LIGHT
Gorilla Cycle Alarm with 2-way paging system / 7017
Includes all the above as well as:
QUANTITY DESCRIPTION
1 5-BUTTON 2-WAY PAGER
1 ANTENNA UNIT WITH WIRING
Tools Needed for Installation
ADJUSTABLE WRENCH OR A PAIR OF PLIERS PLUS A DRILL AND
AN 8MM DRILL BIT FOR LED WARNING LIGHT INSTALLATION. THE GORILLA
CYCLE ALARM IS DESIGNED FOR SIMPLE INSTALLATION.
3
To Next Page
Loading...
Need help?
General
