Headlight lconGear 2
Gear 1
Speed Display
Speed Unit
Mileage Display
Mileage Unit
Gear Button
Power Button
M key
Battery Level Display
Switching Between Single Mileage and Total Mileage Display: While the
dirt bike is on, press the M button to switch the display between single
mileage and total mileage.
Switching Between Miles and Kilometers: While the dirt bike is powered
on, press the gear button and the M button simultaneously for 5 seconds.
This will switch the display unit between miles and kilometers.
Clearing the ODO Mileage: While the dirt bike is powered on, press the
power button and the M button simultaneously for 10 seconds. This will
clear the total mileage, resetting it to zero.
Using the Bell: Use your finger to pluck the bell.
Battery Power Display: When the battery is fully charged, the battery icon
on the display screen will be full (it will show four bars). As you use the dirt
bike’s battery power, the bars in the battery display will decrease in turn.
When there is only one bar left, the battery is at low power and will need to
be charged soon.
12
To Next Page
Loading...
