Maintenance
CLEANING THE VENTURI
If your burner’s flame is overly yellow or
making more noise than usual you may
have debris blocking the venturi. When
the oven is turned off, disconnect it from
the gas and let it cool. Make sure Tread
is on a soft surface that won't cause
scratches before gently rolling it onto
its side. DISCONNECT THE GAS. Use the
torx screwdriver provided to loosen the
4 screws and remove the bottom panel.
The base panel will stay attached with
the wiring looms. Take care when doing
this. Use a vacuum cleaner with a long
plastic nose to remove any debris. It’s
good practice to check the inside of the
dock for debris regularly.
Venturi
WARNING
Take care not to damage any of the wiring
looms when removing the base panel
39
To Next Page
Loading...
