4.3.4 Print DIP Switch function
Print the DIP switch page as follow:
A.Turn off the printer.
B.Make sure the paper roll is installed correctly and the printer top cover is closed.
C.Press and hold PAUSE button and turn on the printer. When paper feed and then
release PAUSE button, DIP switch pagewill be printed out.
DIP SWITCH FUNCTION:
SW1 POWER ON TEST PAPER
OFF ENABLED
ON DISABLED
SW2 SELECT THERMAL DENSITY MODE
OFF ENABLED
ON DISABLED
SW3 SW4 SELECT BAUDRATE
OFF OFF 9600
OFF ON 19200
ON OFF 38400
ON ON 115200
11
4.3.5 Skip AUTO.BAS
User can use TSPL2 command to save a code auto-running file (AUTO.BAS) into
flash. When turn on printer, printer will run the program automatically.
If you want to skip AUO.BAS program on power-up, then follow below steps:
1.Turn off the printer power.
2.Press and hold PAUSE and FEED button, then turn on the printer.
3.When Power indicator (blue) is off and Error indicator(red) is on, release PAUSE
and FEED button.
4. The printer will skip running AUTO.BAS program, and then Power indicator lights.
12
D
ir
e
c
t T
he
r
mal L
a
b
el P
ri
nt
e
r
To Next Page
Loading...