Ar
Remote learning of
transmitters
Enabled
Nt
Disabled
ex
AR REMOTE LEARNING OF TRANSMITTERS- Enables (y5) or disables (nt) remote control learning (see chapter
Remote control self-learning).
rm
Receiver mode
1b
Independent insertion
ex
EXIT or push together
RM RADIO MODE
-1B: Each button of a new transmitter enter separately. User can choose the associated channel (C1 Start/open,
C2 Pedestrian/close, C3 courtesy light command).
- 4B: Once you enter a button of transmitter in memory, All other buttons works. Each button take a channel
between (open, close, pedestrian and stop)
cn
Counter
00
1 pair of digits
00
00
3 pair of digits
EXIT or push together
CN COUNTER Show the counter in 3 groups of 2 numbers. Eaxmple: 123.456 is displayed as : 1.2 - 34. - 56
MM
Mass mode
Y5
Nt
Disabled
EXIT or push together
MM MASS MODE - In this menu you can enable the mass enter mode. This mode can be enabled just when
pause time is 00, this means when automatic closing is disabled. In this mode, if you push 5 times Open
command (example), the control unit count 5 cars passing through the detect sensor, then it closes the barrier.
br
Barrier logic
Nt
Disabled
ex
EXIT or push together
BR BARRIER LOGIC - Enables (y5) or disables (nt) the barrier operating logic. When the barrier logic is disabled,
the control unit uses the standard program to control a sliding gate.
EX
To Next Page
Loading...