8
Pairing a Bluetooth Device
1. Turn on your Bluetooth device.
2. Power on SoundExtreme. “Speaker on, ready to connect” voice
prompt will be heard. If the Bluetooth LED Indicator (the second
LED Indicator from the left) is not flashing, briefly press to
start pairing your device.
3. Navigate to your Bluetooth device’s setup screen, find
ECOXGEAR and connect. If the connection is successful, the
Bluetooth icon will be lit solid and your SoundExtreme will
announce “Your phone is connected.”
Notes:
· If the pairing is not complete within 5 minutes, the speaker will
exit the pairing mode. You need to repeat the pairing steps again.
· After the connection is successful, if you turn the speaker off
and turn it on again, it will reconnect to the last connected
device automatically. Also, a voice prompt, “Speaker on, ready to
connect” followed by, “Your phone is connected” will be heard.
· PRESS AND HOLD for 5 seconds to clear all pairing records.
Adjust Volume
1. Press or briefly to adjust the speaker volume.
2. PRESS AND HOLD or to adjust the volume continuously.
a. Press briefly to increase one volume level. PRESS
AND HOLD to keep increasing the volume until
maximum volume level is reached.
b. Press briefly to decrease one volume level. PRESS
AND HOLD to keep decreasing the volume until
minimum volume level is reached.
To Next Page
Loading...
Need help?
General