Troubleshooting
32 3A4702E
Spray pattern “spits” at the end or
beginning:
Excess material has
accumulated on Spray Tip
and Spray Tip Guard, or
Spray Tip is partially
plugged
Clean Spray Tip and Spray Tip
Guard. Clear Spray Tip. See
Clear Tip Clogs, page 19.
Spray Tip is not fully
inserted into Spray Tip
Guard
See Clear Tip Clogs, page 19.
Spray Tip is worn or
damaged
Replace Spray Tip.
Pump has reached its
maximum life
Replace pump.
Spray Tip continues to drip or ooze
material after Trigger is released:
Spray Tip is worn. Replace Spray Tip. See
Reference, page 25.
Spray Tip not inserted
completely into Spray Tip
Guard.
See Reference, page 25.
Material leaks around Spray Tip
Guard or Spray Tip handle
Spray Tip seal and seat
are damaged or not
properly installed.
See Reference, page 25.
Problem Cause Solution
ti15525a
ti15525a
To Next Page
Loading...
