How to clean clogged spray tip on Graco 248037?
If your Graco Paint Sprayer has low output or pressure, a clogged spray tip could be the cause. Relieve the pressure, then check and clean the spray tip.
What to do if prime valve leaking on Graco 248037?
If your Graco Paint Sprayer has low output or pressure, the prime valve might be leaking. Relieve the pressure, and then repair the prime valve.
What to do if Graco 248037 has low output or pressure because of paint supply?
If you are experiencing low output or pressure with your Graco Paint Sprayer, ensure that the paint supply is adequate. Refill the paint and reprime the pump.
How to clean intake strainer on Graco Paint Sprayer?
If your Graco Paint Sprayer has low output or pressure, the intake strainer might be clogged. Remove and clean the intake strainer, then reinstall it.
How to clean filter on Graco Paint Sprayer?
If your Graco Paint Sprayer has low output or pressure, the filter might be clogged. Relieve the pressure, then check and clean the filter.
Why is there leaking around throat packing nut on my Graco 248037?
If your Graco Paint Sprayer has low output or pressure, leaking around the throat packing nut may indicate worn or damaged packings. Replace the packings. Also check the piston valve seat for hardened paint or nicks and replace if necessary. Tighten the packing nut/wet-cup.
What to do if Graco 248037 has low output or pressure because of low stall pressure?
If your Graco Paint Sprayer has low output or pressure because of low stall pressure, you can try either or both of the following: Turn the pressure control knob fully clockwise, ensuring it is properly installed to allow the full clockwise position, or try a new pressure transducer.
What to do if my Graco 248037 Paint Sprayer motor runs but the pump doesn't stroke?
If the motor of your Graco Paint Sprayer runs but the pump doesn't stroke, it could be due to a damaged or missing displacement pump pin (remedy: replace the pump pin, ensuring the retainer spring is fully in the groove around the connecting rod), damage to the connecting rod assembly (remedy: replace the connecting rod assembly), or damage to the gears or drive housing (remedy: inspect and replace if necessary).
What to do if the motor runs but the pump does not stroke on my Graco 248037 Paint Sprayer?
If your Graco Paint Sprayer's motor runs but the pump doesn't stroke, it could be due to a damaged or missing displacement pump pin. Replace the pump pin if it's missing, ensuring the retainer spring is fully in the groove all around the connecting rod. Another potential issue is damage to the connecting rod assembly; if so, replace the connecting rod assembly. Also, inspect the drive housing assembly and gears for damage and replace if necessary.
Why intake valve ball and piston ball are not seating properly on Graco 248037 Paint Sprayer?
If your Graco Paint Sprayer has low output or pressure, it could be because the intake valve ball and piston ball are not seating properly. Remove the intake valve and clean it. Check the balls and seats for nicks and replace if necessary. It is also advisable to strain paint before using to remove particles that could clog the pump.
General| Model | 248037 |
|---|---|
| Category | Paint Sprayer |
| Type | Airless |
| Max Pressure | 3000 PSI |
| Flow Rate | 0.27 GPM |
| Hose Length | 25 ft |
| Power Source | Electric |
| Voltage | 120V |
| Amperage | 7A |
| Maximum Tip Size | 0.015 in |
| Tip Size | 0.015 in |
To Next Page
