How to check suction hose connections on Graco 248037?
If your Graco Paint Sprayer has low output or pressure, check the suction hose connections. Tighten any loose connections and check for missing or damaged seals.
Why does my Graco 248037 have low output or pressure?
If your Graco Paint Sprayer has low output or pressure, several factors could be responsible. Start by relieving the pressure and inspecting the filter for clogs, cleaning it if necessary. A clogged spray tip could also be the culprit; relieve the pressure and then check and clean it. Ensure the paint supply is adequate by refilling and repriming the pump. Also, inspect the intake strainer, removing and cleaning it before reinstalling. Check suction hose connections and tighten any loose ones, looking for damaged seals. If the prime valve is leaking, relieve the pressure and repair it. In case of leaking around the throat packing nut, replace the packings and check the piston valve seat for hardened paint or nicks, replacing if needed, and tighten the packing nut/wet-cup. For low stall pre...
Why is the Graco 248037 having low output or pressure?
There are several potential reasons for low output or pressure in your Graco Paint Sprayer. It could be due to a worn or clogged spray tip (remedy: relieve pressure, then replace or clean the tip), low paint supply (remedy: refill and reprime the pump), a clogged intake strainer (remedy: remove, clean, and reinstall it), or clogged filter (remedy: relieve pressure, then check and clean the filter). Other potential causes include loose suction hose connections (remedy: tighten connections and check seals), a leaking prime valve (remedy: relieve pressure and repair the valve), issues with the intake valve ball and piston ball (remedy: remove and clean the intake valve, check balls and seats, and strain paint before using), leaking around the throat packing nut (remedy: replace packings and c...
General| Model | 248037 |
|---|---|
| Category | Paint Sprayer |
| Type | Airless |
| Max Pressure | 3000 PSI |
| Flow Rate | 0.27 GPM |
| Hose Length | 25 ft |
| Power Source | Electric |
| Voltage | 120V |
| Amperage | 7A |
| Maximum Tip Size | 0.015 in |
| Tip Size | 0.015 in |
To Next Page
