To Next PageTo Next PageWhy is the flow reading inaccurate on my Graco Measuring Instruments?
If you're getting inaccurate flow readings on your Graco Measuring Instruments, the flow meter sensor or the meter itself may be faulty and require replacement. Another cause could be that the meter needs calibration.
What to do if the pressure or flow rate reads 0 when fluid is flowing on Graco Measuring Instruments?
If the pressure or flow rate reads 0 on your Graco Measuring Instruments when fluid is flowing, the flow meter or pressure transducer cable might be loose or disconnected. Check the digital input/output cable going to or from the meter to resolve this.
How to troubleshoot inaccurate pressure range in Graco Measuring Instruments?
If you're experiencing an inaccurate pressure range with your Graco Measuring Instruments, it could be due to selecting the wrong transducer. Ensure the correct transducer is chosen. Also, review and correct the settings for the pressure offset (mV) and slope (mV/bar).
What causes fluid not flowing in Graco Measuring Instruments?
If fluid is not flowing in your Graco Measuring Instruments, it may be due to clogs in the fluid line or meter. Clean the fluid line and/or meter. Another cause could be worn or damaged gears.
What to do if higher fluid pressure cannot be achieved with Graco Measuring Instruments?
If higher fluid pressure cannot be achieved with your Graco Measuring Instruments, check the incoming system air pressure and incoming fluid pressure from the pump. Also, check I/P pilot line output pressure and power output of the barrier that powers the system.
What causes low flow in Graco Measuring Instruments?
Low flow in your Graco Measuring Instruments may be due to inadequate air supply through the I/P transducer. Try increasing the incoming air pressure.
How to fix a completely dark Graco Measuring Instruments ProControl 1KE Plus?
If your Graco Measuring Instruments ProControl 1KE Plus is completely dark, first ensure that the power supply is turned on. If the power is on, check for loose or disconnected power cables and tighten or reconnect them.
What to do if Graco Measuring Instruments ProControl 1KE Plus has power but does not function?
If your Graco Measuring Instruments ProControl 1KE Plus has power but isn't functioning, it may be due to a hardware failure, requiring replacement of the ProControl 1KE Plus.
How to fix communication failure in Graco Measuring Instruments?
If you are experiencing a communication failure with your Graco Measuring Instruments, check the address configuration, communication parameters, cabling, and wiring.
Why does Graco Measuring Instruments pressure or flow rate read “— — —” all the time?
If the pressure or flow rate on your Graco Measuring Instruments consistently reads “— — —”, it indicates that the units in Setup are set to NONE, meaning the system recognizes no pressure transducer or fluid meter. Choose preferred units for each device present.
General| Brand | Graco |
|---|---|
| Model | 24L097 |
| Category | Control Unit |
| Language | English |
