Graco Magnum ProX7 Repair And Parts

Graco Magnum ProX7

52 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Repair and Parts

X5

™

, X7

™

, ProX7

™

& ProX9

™

Airless Sprayers

312667K

EN

- For portable spray applications of architectural paints and coatings. For professional use

only-

X5 and X7 Models ONLY: Use water based or

mineral-spirit type material only. Do not use materials

having flash points lower than 70°F (21°C). This

includes, but is not limited to, acetone, xylene,

toluene, or naptha. For more information about your

material request MSDS from distributor or retailer.

Models 262800, 262805, 261815, 261820

See page 3 for model and series information including

dispense rate, recommended hose length, guns, and

maximum working pressure.

IMPORTANT SAFETY INSTRUCTIONS.

Read all warnings and instructions in this manual.

Save these instructions.

Related Manual

312001

MAGNUM ProX9

Model: 261820

ti16976a

ti9369a

M

AGNUM

ProX7

Model: 261815

MAGNUM X5

Model: 262800

ti11304a

Model: 262805

MAGNUM X7

ti11305a

Series A, B, C, D

Series A, B, C

Series A

Series A

MAGNUM ProX9

Model: 261820

Series B

ti9368a

M

AGNUM

ProX7

Model: 261815

Series B

ti9369b

Visit our website;

http://M

AGNUM.Graco.com

Table of Contents

Other manuals for Graco Magnum ProX7

Operation28 pages

Questions and Answers:

A
Angela ReedSep 9, 2025
Why is my Graco Magnum ProX7 Paint Sprayer motor hot and running intermittently?
- B
  Briana OnealSep 10, 2025
  If the motor of your Graco Paint Sprayer is hot and runs intermittently (not due to thermal overload), ensure the vent holes in the enclosure are clear of obstructions and overspray, and keep the sprayer open to air. Replace the extension cord if it is too long or not a heavy enough gauge. If using an unregulated electrical generator, ensure it has a proper voltage regulator (120VAC, 60 Hz, 1500-Watt). If the sprayer was operated at high pressure with a very small tip, decrease the pressure setting or increase the tip size.
C
Cheryl RichardsonAug 25, 2025
What to do if Graco Paint Sprayer spray gun stopped spraying?
- A
  andrewblackAug 26, 2025
  If your Graco Paint Sprayer has stopped spraying, consider these potential causes: * The pump might not have been primed with flushing fluid. Remove the suction tube from the paint and prime the pump with water or flushing solvent-based flushing fluid. * The suction tube could be leaking. Tighten the suction tube connection and inspect it for cracks or vacuum leaks. * The spray tip might be clogged. Unclog the spray tip.
J
jamescharlesAug 27, 2025
Why is paint leaking from the pump of my Graco Paint Sprayer?
- A
  Andrew AbbottAug 27, 2025
  If paint leaks down the outside of the pump of your Graco Paint Sprayer, it means the pump packings are worn and need to be replaced.
A
April LewisAug 27, 2025
What to do if my Graco Magnum ProX7 Paint Sprayer power switch is on but the motor doesn't run?
- B
  Bryan LopezAug 28, 2025
  If your Graco Paint Sprayer's power switch is on and the sprayer is plugged in, but the motor doesn't run, first ensure that the pressure isn't set to zero; turn the pressure control knob clockwise to increase the pressure setting. Then, check if the electric outlet is providing power by verifying that the lighted plug on the sprayer is lit; if not, reset the building circuit breaker or replace the fuse. A damaged extension cord or sprayer electric cord could also be the culprit, so inspect and replace them if necessary.
H
Holly SandersAug 29, 2025
Why does paint run or sag when using Graco Magnum ProX7?
- B
  butlertimothyAug 29, 2025
  If your Graco Paint Sprayer is spraying paint that runs down the wall or sags, it's likely due to applying too much paint. Try moving the gun faster. You may need to choose a tip with a smaller hole size or a wider fan. Also, ensure the gun is far enough from the surface.
D
Dawn WrightAug 30, 2025
Why Graco Paint Sprayer pump cycles but does not build pressure?
- O
  obrienkimberlyAug 30, 2025
  If your Graco Paint Sprayer pump cycles but doesn't build up pressure, try the following: * Prime the pump. * Check the inlet screen for clogs and ensure the suction tube is immersed in the fluid. Clean any debris off the inlet screen. * Refill the paint pail and re-prime the sprayer if the paint pail is empty. * Inspect the suction tube for leaks. Tighten the connection and look for cracks or vacuum leaks. Replace the tube if damaged.
C
Catherine MosleySep 14, 2025
Why is Graco Magnum ProX7 spraying two thick streams?
- A
  Alexander WellsSep 14, 2025
  To fix this, rotate the arrow-shaped handle on the spray tip of your Graco Paint Sprayer so it points forward in the SPRAY position.
B
Brooke StevensonSep 12, 2025
Why does Graco Paint Sprayer trip circuit breaker?
- E
  Emily MartinSep 12, 2025
  If the building circuit breaker opens after your Graco Paint Sprayer operates for 5 to 10 minutes, try freeing up the circuit by unplugging other appliances or use a less busy circuit. Check the sprayer's electrical cord for broken insulation or wires and replace it if damaged. Test the extension cord with a working device and replace it if damaged or too long, or not heavy enough gauge.
D
Damon ReedSep 8, 2025
Why is Graco Paint Sprayer coat not covering?
- M
  Michael PughSep 8, 2025
  If, when using your Graco Paint Sprayer, the coat is not covering, it is likely because the coat is going on too thin. Try moving the gun slower. You may need to choose a tip with a larger hole size or a narrower fan. Also, make sure the gun is close enough to the surface.
U
ubrownSep 5, 2025
Why is Graco Magnum ProX7 Paint Sprayer spray pattern inconsistent?
- J
  joseph07Sep 5, 2025
  If the spray pattern of your Graco Paint Sprayer is inconsistent or leaving stripes, it might be due to: * Low pressure. Increase the pressure by turning the Pressure Control Knob clockwise. * A worn spray tip. Replace the spray tip.

Graco Magnum ProX7 Specifications

General

Brand	Graco
Model	Magnum ProX7
Category	Paint Sprayer
Language	English

Related product manuals

Preview: Graco Magnum ProX

Graco Magnum ProX

Graco Magnum ProX9

Preview: Graco Magnum TrueAirless ProX19

Graco Magnum TrueAirless ProX19

Preview: MAGNUM PROJECT PAINTER PLUS

MAGNUM PROJECT PAINTER PLUS

Preview: Magnum True Airless Project Painter Plus

Magnum True Airless Project Painter Plus

Preview: Graco Magnum

Preview: Graco Magnum X5

Graco Magnum X5

Graco Magnum X7

Graco MAGNUM LTS 17

Preview: Graco MAGNUM 309225W

Graco MAGNUM 309225W

Preview: Graco Magnum DX 232735

Graco Magnum DX 232735

Preview: Graco Magnum True Airless X5

Graco Magnum True Airless X5