21
g
h
LATCH
6. Hold seat and pull front to back and left to right at belt path
to check for secure installation (g). The child restraint should
not move side to side or forward more than 1 inch (2.5 cm).
Check that the lower anchor belt stays tight and does not
slip from the tightened position. If it does not stay tight, try
another seating position or contact Customer Service.
7. Check level indicator on child restraint (h).
Vehicle must be on level ground and child in
child restraint when checking level indicator.
Ball MUST be entirely in blue zone (h). If
necessary, place rolled towels under child
restraint, at vehicle seat crease, until entire ball is
in blue zone. Then re-check level indicator.
(See page 36-37, fig. e)
• DO NOT use tether
rear-facing. Tether must be
stored (see “Tether Storage” page 49).
• Periodically check that child restraint is securely
installed and properly leveled; adjust if necessary.
• To remove LATCH, see “Removing LATCH from
Vehicle Anchor Points”, p. 39.
To Next Page
Loading...
Need help?
General