20
REAR-FACING INSTALLATION WITH LATCH
1. Pull out on handle on front of child
restraint (a) and adjust to rear-facing
position 1 (b). Make sure
forward-facing LATCH belt is stored.
(see fig. c, pg. 40)
2. Place rear-facing on vehicle seat
equipped with LATCH anchors.
3. For ease of installation, extend
LATCH belt to its maximum length.
4. Attach rear-facing connectors to
vehicle lower anchors (c). Belt must lie
flat and not be twisted. Pull connectors
to be sure they are securely attached to
the anchor points. (d).
5. Press down firmly in center of child
restraint while pulling LATCH
adjustment belt through slot in
seat pad (e). When finished tightening,
make sure free end of adjustment belt is
outside the seating area (f).
a
b
d
e
c
f
CLICK!
Slot
To Next Page
Loading...
