25
4. Hold seat and pull front to back and left to right at the belt
path to check for secure installation. (f). The child restraint
should not move side to side or forward more than 1 inch
(2.5 cm).Vehicle lap belt MUST stay tight. If not secure, see
“Vehicle Seat Belts”page 41.
5. Check level indicator on child restraint. Vehicle must be on
level ground and child in child restraint when
checking level indicator.
6. Ball MUST be entirely in blue zone (g). If
necessary, place rolled towels under child
restraint, at vehicle seat crease, until entire ball is
in blue zone. Then re-check level indicator.
(See page 36-37, fig. e)
DO NOT use tether rear-facing. Tether must be
stored (see “Tether Storage” page 49).
Periodically check that child restraint
is securely installed and
properly leveled; adjust if
necessary.
g
f
Towel
To Next Page
Loading...
