27
5. Press down firmly in center of child
restraint to compress vehicle seat
cushion while tightening vehicle seat
belt (e).
6. Hold seat and pull front to back and
left to right at belt path to check for
secure installation (f). The child
restraint should not move side to side
or forward more than 1 inch (2.5 cm).
Vehicle lap belt MUST stay tight. If not
secure, see “Vehicle Seat Belts” pg. 41.
7. Attach tether strap hook (A) to anchor
hardware (B) and tighten adjustment
belt to remove any slack (g). If vehicle
does not have anchor points to attach
tether hook, tether hook should be
stored, see “Tether Storage”, page 49.
Belt must lay flat and not be twisted.
Periodically check that child restraint is
securely installed; adjust if necessary.
f
Installation with
Lap/ Shoulder
belt
LATCH
(stored)
Tether
g
Pull to
Tighten
A
B
e
To Next Page
Loading...
Need help?
General