Graco T Series - Fire and Explosion Hazard; Equipment Misuse Hazard

3306–667
WARNING
FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury .
D
Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or the fluid being
sprayed.
D
Extinguish all the open flames or pilot lights in the spray area.
D Electrically disconnect all the equipment in the spray area.
D Keep the dispensing area free of debris, including solvent, rags, and gasoline.
D Do not turn on or of f any light switch in the spray area while operating or if fumes are present.
D Do not smoke in the spray area.
D Do not operate a gasoline engine in the spray area.
D If there is any static sparking while using the equipment, stop spraying immediately . Identify and
correct the problem.
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in a serious injury .
D This equipment is for professional use only .
D
Read all the instruction manuals, tags, and labels before operating the equipment.
D Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D Check the equipment daily . Repair or replace worn or damaged parts immediately .
D
Do not exceed the maximum working pressure of this equipment. This system has a 21.0 MPa,
210 bar (3000 psi) maximum working pressure.
D Use fluids that are compatible with the equipment wetted parts. See the T echnical Data section of
all the equipment manuals. Read the fluid manufacturer ’ s warnings.
D Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 82 _ C (180 _ F) or below –40 _ C (–40 _F).
D
Do not use the hoses to pull equipment.
D W ear hearing protection when operating this equipment.
D Comply with all applicable local, state, and national fire, electrical, and other safety regulations.