Operation
20 3A6491E
Cleanup
1. Perform Pressure Relief Procedure,
page 12.
2. Remove tip guard and Spray Tip. For
additional information, see separate gun
manual.
Fast Flush Drain Tube
3. Remove fluid intake and drain tube from
paint, wipe excess paint off outside.
4. Place fluid intake in flushing fluid. Use
water for water base paint and mineral
spirits for oil-based paint. Place drain
tube in waste pail.
5. To flush drain tube and pump turn prime
valve down.
6. Turn pressure control to Fast Flush
operate until the pump runs steady and
flushing fluid appears in the waste pail.
To Next Page
Loading...
