Shutdown and Cleaning
312001G 19
Power Flush
Power flushing is a faster method of flushing. It can
only be used after spraying water-based coatings.
1. Relieve pressure, page 9.
2. Remove tip and guard assembly from gun and
place in waste pail.
3. Place empty waste and
paint pails side by side.
4. Lift suction tube and prime tube from paint pail.
Let them drain into paint for a while.
5. Place suction and prime tube in waste pail.
6. Turn Pressure Control knob to the
Prime/Clean setting.
7. Screw power flush attachment
to garden hose. Close valve.
8. Turn on water. Open valve.
Rinse paint off suction tube,
prime tube and inlet screen.
9. Turn lever to close power flush
attachment.
10. Unscrew inlet screen from suction
tube. Place inlet screen in waste
pail.
11. Connect garden hose to suction
tube with Power Flush attachment.
Leave prime tube in waste pail.
12. Turn power switch ON.
13. Open lever on Power
Flush attachment.
14. Circulate water through sprayer, into waste pail,
for 20 seconds.
15. Turn power switch OFF.
ti9726a
ti9344a
ti9413a
ti9727a
ti2040a
ti2042a
ti5580a
OPEN
ti2043a
ti2018a
To Next Page
Loading...
Need help?
General
