To Next PageTo Next Page
Need help?Do you have a question about the Graco XP and is the answer not in the manual?
General| Spray Technology | Airless |
|---|---|
| Power Source | Electric |
| Typical Applications | Industrial Coatings |
| Flow Rate | 0.5 GPM |
| Hose Length | 100 ft |
Provides crucial safety guidelines for equipment setup, use, and maintenance, emphasizing hazard avoidance.
Defines pressure ranges for automatic operation, monitoring, and potential shutdowns, including minimum and maximum limits.
Details maximum allowable pressure set points for different models to prevent over-pressurization and ensure safety.
Details the functions of the Up/Down arrows and Soft Keys used for navigating and interacting with the display menus.
Explains the meaning of icons displayed on the screen that correspond to soft key actions like Enter, Exit, and Cancel.
Shows A and B pressures during spraying, indicating normal operation with balanced pressures.
Displays A and B pressures when the system is in circulation mode, with specific alarms still active.
Indicates an active alarm condition, showing current pressures and potentially an alarm code.
Shows an active deviation, displaying A and B pressures and an indicator for the deviation.
Step-by-step guide for installing the Pressure Trak onto an XP sprayer equipped with an NXT motor.
Step-by-step guide for installing the Pressure Trak onto an XP-hf sprayer equipped with an Xtreme XL motor.
Instructions for initiating the XP Pressure Trak and sprayer system, including waking the display.
Procedures for safely shutting down the sprayer and the Pressure Trak, entering hibernation mode.
Guidance on entering setup mode and setting system parameters before commencing spraying operations.
Detailed steps to clear active alarms, including shutting down air pressure and verifying conditions.
How to toggle between the Alarm Information screen and the Run Alarm Active screen to monitor alerts.
Accessing the error log screen to review recent advisory or alarm error codes and their occurrence times.
A comprehensive list of error codes, their causes, and recommended solutions for troubleshooting system issues.
Instructions for replacing the Pressure Trak module battery and fuse in a non-hazardous location.
Procedure to retract the solenoid if the unit has a dead battery and no replacement is available.
Lists and illustrates the components included in the 17G807 and 17G808 Pressure Trak kits.
Lists and illustrates the components included in the 17N936 Pressure Trak kit.
Explains how to enter setup mode and the system configuration data that can be viewed or modified.
Details settings for measurement units, deviation pressure, and alarm pressure within the setup interface.
Configures high pressure limit, minimum spray pressure, and B pressure offset for system operation.
Allows scrolling through error logs and clearing them, displaying error numbers, codes, and timestamps.
Procedure to set or deactivate a password for accessing setup screens to enhance security.
Display showing A and B pressures during spray mode, indicating system readiness and monitoring.
Display for circulation mode, showing A and B pressures with specific alarms active, below spray pressure limit.
Screen indicating an active alarm, showing current pressures and system status, often with a flashing red LED.
Display indicating an active deviation, showing A and B pressures and a deviation status icon.
Provides active alarm code and A/B pressures at the time of the alarm, toggled with Alarm Active screen.
Emergency mode where the Pressure Trak stops monitoring, requiring manual setting of pressure limits.
An optional accessory consisting of removable shields to protect the membrane switch from daily wear.
Contact and website information for Graco products, patents, ordering, and technical support.
