6
630-653-3377 for the manual that explains in
detail the setting of these specific options for
printer or computer connections. This
(previous) option became a standard feature
in 2013.
13. Press the “Print/Send/Data” pushbutton.
The scale will display “PC brd” (printed
circuit board). Pressing the
“Print/Send/Data” pushbutton again will
display the model number of the printed
circuit board (i.e.”23005”). Another press of
the “Print/Send/Data” pushbutton will show
the revision level of the printed circuit (i.e.
“02”). These are provided for informational
trouble-shooting purposes and cannot be
changed in set-up mode.
14. Pressing the “Print/Send/Data” pushbutton
one last time returns the scale to the
introductory “SEt-UP” mode. The scale may
be turned off by pressing and holding the
“On / (OFF) / ZERO” pushbutton. If running
on batteries, the scale will automatically
shut-off after three (3) minutes. (The
selected automatic shut-off time is
temporarily lengthened when the scale is
operating in the special “set-up” mode.)
To Next Page
Loading...