BIOBASIC MANUAL
|
13
The appliance must be connected to the external power supply using a
suitable device which mechanically prevents the plug and socket from
being separated unintentionally. The connection must be labelled:
”DO NOT SEPARATE WHEN ENERGIZED” .
Fuses and similar must never be removed or replaced while the
appliance is connected to a power source. The electrical terminal box
must never be opened while the appliance is connected to a power
source. The compressor starting equipment must never be dismantled
while the appliance is connected to a power source. The LED lighting
must never be dismantled while the appliance is connected to a power
source. Whenever electrical components are dismantled or replaced,
the appliance must be moved to an area in which there is no risk of
ignition caused by the electrical components or gases contained in the
appliance. Never use the cabinet if the plug is damaged. The cabinet
should be examined by a Gram Commercial A/S authorised service
technician in such cases.
In both cases:
Use a three-wire plug, if the power outlet is intended for a three-wire
plug, the lead in green / yellow insulation should be connected to the
ground terminal. Power must be connected via a wall socket. The wall
socket should be easily accessible. All earthing requirements stipulated
by the local electricity authorities must be observed. The cabinet plug
and wall socket should then give correct earthing. If in doubt, contact
your local supplier or authorized electrician.
In case of technical diculties or breakdowns, always
contact authorized service personnel. Never dismantle the
terminal box or any other electrical component.
To Next Page
Loading...
Need help?
General
