6
|
BIOBASIC MANUAL
Installation
Due to safety and operating reasons, the cabinet must not be used
outdoors. The cabinet should be installed in a dry and suciently
ventilated area. To ensure ecient operation, the cabinet should not be
installed in direct sunlight or close to heat sources.
Avoid placement of the cabinet in a chloric/acidic environment due to
risk of corrosion.
Clean the cabinet with a mild soap solution prior to use.
If the cabinet has been laying down (e.g. during transport.).
The cabinet must stand up-right for 24 hours prior to being turned on.
Initial setup steps
Certain cabinets are shipped
with a protective lm that
should be removed prior to
putting the cabinet into service.
To Next Page
Loading...
