7
USE OF CRANE SCALE
Turn ON
Press the key on the crane, the scale begin the self test, at the same
time, auto-zero initialization, then the display will show power status “Pbt85”
(85% power) and finally the crane scale enters to weighing mode.
Turn OFF
Press the
key for 3 seconds or D and B together on remote control, the
display will show “PA80” (80% power), 1.5 seconds later, the display will
show “off” and scale power off.
Tare / Zero
To obtain the net weight of a product. Place a container and press the
key or B on remote control, the display shows zero value, put the product into
the container, the display will show the net weight of the product.
Display brightness
1. With the crane scale disconnected, press the key
the same time
press also the key .
2. The display will show: “Dsp X”.
3. Available options:
X=0 Low brightness.
X=1 High brightness.
X=2 Automatical brightness (when weight changes, the high
To Next Page
Loading...
